The BreakPoints window

Figure 1: BreakPoints window

Working with the BreakPoints window

Table 1:  Working with the Breakpoints window.
------------------------------------------------------
To...           |Do this...                           
------------------------------------------------------
Open the window |Press Command-U, or select           
                |BreakPoints from the View menu.      
------------------------------------------------------
Set a breakpoint|Enter the breakpoint address or a    
                |function name into the edit box to   
                |the right of the Set button, then    
                |click Set. The source line or        
                |disassembly line is marked with a    
                |bullet ().                           
------------------------------------------------------
Remove a        |Click on a breakpoint in the list to 
breakpoint      |select it, then click Clear. The     
                |bullet in the left margin of the     
                |Source or Disassembly window is      
                |replaced with a pound sign (#).      
------------------------------------------------------
Set conditional |Click on the Condition box.See Using 
breakpoints     |conditional breakpoints from the     
                |Source window.                       
------------------------------------------------------

Note: You can place hard-coded breakpoints into the source code if you include debug.h in that file. Putting a Debugger(); statement anywhere in the code will then cause a breakpoint. Use Ignore Software Breakpoints in the Preferences dialog if you want to run your program without stopping at these breakpoints.